Remove the lower rack, twist out the filter at the bottom of the tub, rinse it under warm water, scrub gently with a soft brush, and lock it back in. That’s how to clean a dishwasher filter parts, and it usually takes just a few minutes. This dishwasher filter cleaning guide also covers filter types, what to do if dishes still come out dirty or smelly, and when a drain or pump problem needs a technician.
Where Is the Filter in a Dishwasher?
Usually at the bottom of the tub, under the lower spray arm. Pull out the lower rack and look at the floor of the tub for a round twist-lock piece or a flat mesh panel.
Do all dishwashers have filters? Most do, but designs vary. Some models have a self-cleaning filter with a built-in food disposer and little or no manual cleaning. Your manual will say which type you have.
Dishwasher Filter Types Explained
- Cylinder filter: a round tube in the centre that twists to unlock.
- Flat or fine mesh filter: sits under or around the cylinder and catches smaller particles.
- Triple filter system: a coarse filter, a fine filter, and a cylinder working together. Pull all the pieces apart.
- Self-cleaning filter: no routine removal, though the manual may still suggest an occasional check.
Bosch, Miele, Whirlpool, KitchenAid, LG, and Samsung all use slightly different layouts. A Miele dishwasher filter, for example, is often a multi-part assembly. Twist directions and positions differ, so check your manual before pulling anything out.
On a Whirlpool dishwasher filter change, note that filters are normally cleaned, not replaced. If yours is cracked, torn, or warped, look up the replacement by model number.
What Happens If You Don’t Clean the Dishwasher Filter?
A clogged dishwasher filter restricts water flow and lets food particles recirculate. Look for:
- Gritty or cloudy dishes and glasses
- A musty or rotten-food smell
- Water left standing at the bottom of the tub
- Dishes that still look dirty after a full cycle
How to Clean a Dishwasher Filter: Step by Step
This is also how to clean a filter on a dishwasher with several parts, using only warm water and a soft brush. Check your manual first, since filter designs differ.
- Empty the dishwasher and remove the lower rack.
- Unlock the filter. Most twist counterclockwise and lift out. Dishwasher filter cleaning is easiest if you clean filter dishwasher pieces one at a time, so you remember how they fit back together.
- Check for debris. Look for glass shards, bones, or labels. Wear gloves.
- Rinse under warm running water. To clean dishwasher filter mesh properly, rinse from the inside out.
- Scrub gently. A soft brush or old toothbrush works. Add a drop of dish soap for grease. This dishwasher cleaning filter method needs no special cleaner.
- Wipe the area underneath. Use a cloth around the drain filter dishwasher opening, without pushing debris down into it.
- Reinstall and lock. Make sure every piece sits flush. Cleaning dishwasher filter parts is pointless if they’re loose.
What Not to Do
- Don’t use wire brushes or steel wool. They can damage the mesh.
- Don’t force a stuck part. Cracked plastic costs more than a stuck filter.
- Don’t run the machine without the filter. Can you run a dishwasher without a filter? It’s not recommended because food and debris can reach the pump and drain.
- Don’t go further than the filter. Removing panels or touching wiring is a technician’s job.
How Often Should You Clean a Dishwasher Filter?
This dishwasher filter cleaning frequency chart is a rule of thumb. Your manual comes first.
| How you use it | Check and clean |
| Daily, with heavy or greasy loads | About once a week |
| A few cycles a week | About once a month |
| Occasional use | Every two to three months |
Use this dishwasher filter maintenance checklist between cleanings:
- Scrape large scraps off plates
- Check the filter on your schedule
- Confirm it’s locked in after every clean
- Replace it if it’s cracked
Many washers have a drain filter too. If yours won’t drain, see our washing machine repair page.
Still Dirty, Smelly, or Gritty After Cleaning?
- Dirty dishes: check that the filter is locked in, the spray arm holes aren’t blocked, and the racks aren’t overloaded.
- Bad smell: trapped food under the filter is a common cause. If the dishwasher filter clogged again quickly, scrape plates more carefully.
- Standing water: this usually points to a drain pump or drain line problem, which a clean filter won’t fix.
- Gritty glasses: a loose or misaligned filter can let particles recirculate.
When to Call a Technician
Call a technician if standing water returns after cleaning, you hear unusual noises while it drains, there’s a leak or an error code, or the filter won’t come out.
If you’re searching dishwasher repair near me, DS Appliance Rescue offers dishwasher repair and installation, and covers dishwasher repair Edmonton homeowners can book. A visit means diagnosing the problem, explaining the repair options, and giving an upfront estimate before work starts. For dishwasher not cleaning dishes repair, or a trusted dishwasher repair technician to check the drain and pump, see our dishwasher repair in Edmonton page. Local dishwasher service Edmonton appointments depend on availability.
FAQs
How do you remove a stuck dishwasher filter?
Check your manual for the unlock direction and any release tab, then use gentle, steady pressure. Don’t use pliers or force it. If it still won’t budge, book a technician.
Do I need a cleaner for the filter?
No. Warm water and a soft brush are enough. Add a drop of dish soap for greasy buildup.
Next Step
A clean filter fixes many dishwasher problems, but not drain or pump faults. If dishes are still dirty or water won’t drain, book dishwasher repair in Edmonton or explore our full appliance repair Edmonton services at appliance repair Edmonton. Leduc homeowners can reach us for dishwasher repair Leduc through our appliance repair in Leduc page.